Updated at: 2022-12-09 03:49:50
Stopping recovery jobs during running is supported.
Considerations:
§ Stopping recovery jobs may cause the restored data unavailable.
§ When a recovery job is stopped and started again, resumable data transfer will be not supported, and data will be restored again.
§ If part of the data is already restored to the destination platform after a recovery job is stopped, this part of data will be cleaned up.
To stop recovery jobs,
Step 1 Log into the console as a tenant or an operator.
Step 2 Click Backup and Recovery＞Data Backup＞Restore Backup Data, to enter the Restore Backup Data tab.
Step 3 Select a job in Running, click Stop, the Stop job dialog box pops up.
Step 4 Review the tips carefully, then click Stop to complete the operation.
When the job running status is displayed as Stopped on the Restore Backup Data tab, the job has been successfully stopped.
Considerations:
§ Stopping recovery jobs may cause the restored data unavailable.
§ When a recovery job is stopped and started again, resumable data transfer will be not supported, and data will be restored again.
§ If part of the data is already restored to the destination platform after a recovery job is stopped, this part of data will be cleaned up.
To stop recovery jobs,
Step 1 Log into the console as a tenant or an operator.
Step 2 Click Backup and Recovery＞Data Backup＞Restore Backup Data, to enter the Restore Backup Data tab.
Step 3 Select a job in Running, click Stop, the Stop job dialog box pops up.
Step 4 Review the tips carefully, then click Stop to complete the operation.
When the job running status is displayed as Stopped on the Restore Backup Data tab, the job has been successfully stopped.
< Previous:
Next: >